The land-claim plugin on the server has been swapped out. GriefPrevention3D v19.0.1 replaces the plain GriefPrevention build we were running, and it is a drop-in replacement — every claim on the server carried over untouched, and none of the commands you already know have changed.

The reason for the swap was a limitation of the old plugin: it could not do height-limited claims, and it had no way to stop two players from claiming land right next to each other. Both of those are now fixed.

What you can do differently now

3D subdivisions

The big one. A normal subdivision in the old plugin was a flat rectangle cut out of a claim, extending the full height of the world — so a public lobby inside your base was protected from floor to sky. A 3D subdivision has an exact Y-level floor and ceiling.

Switch to it with /3dsubdivideclaims, then use the golden shovel to set the corners. You can now, for example, protect a shop's ground floor and leave the floors above it open for other players to build in.

A minimum distance between claims

New claims now have to sit 100 blocks away from any other player's claim. Previously two claims could be placed edge to edge, which made it trivial to wall someone in or to claim a strip of land next to a neighbour's base just to be annoying.

If you try to claim too close, you get:

You can't create a claim here because it's too close to {player}'s claim. Minimum distance is 100 blocks.

The check applies to top-level claims only — subdivisions inside your own claim are unaffected.

Merging claims

If you ended up with two separate claims next to each other and want them as one, /mergeclaims joins them, including the gap between them. Stand in the first claim, run it, then stand in the second and run it again (or right-click the boundary with your golden shovel).

Scroll resize

/scrollresize resizes a claim or subdivision with the mouse wheel instead of re-clicking corners. Scroll up to push the far edge away, scroll down to pull it in. You get a live preview of the new boundary before you apply it, and it works down to single-block precision. Right-click to confirm, left-click to cancel.

The new commands

Command What it does
/3dsubdivideclaims Switch the shovel to 3D subdivision mode
/mergeclaims Merge two of your claims into one
/scrollresize Resize a claim with the mouse wheel
/checkclaimdistance Show the minimum distance setting and list nearby claims
/neighbortrust <player> Let one player bypass the distance check on your claims
/toggleclaimdistance Let everyone bypass the distance check on your claim

/neighbortrust is the escape hatch if you and someone genuinely need bases near each other. Grant it once and they can build next to you without the 100-block rule getting in the way.

There is also a unified /claim command now — /claim create, /claim trust, /claim abandon and so on — if you prefer one entry point over a dozen separate ones. The old commands all still work.

How many claims you can have

You can hold 5 claims at a time — the same number of homes you can set with /sethome <name>. If you need more room, /abandonclaim removes one of your claims and frees the slot for a new one.

What did not change

  • Your claims, your claim points, your trust levels — all carried over from the old plugin. Nothing was reset.
  • The golden shovel and the stick still work exactly the same way for creating, resizing and inspecting ordinary 2D claims.
  • Claim points still accrue at 100 per hour, up to 30,000.
  • The Nether and The End still have claims disabled.

A couple of things to know

Shaped (non-rectangular) claims and nested subdivisions are available in this plugin but are currently switched off in the server config. If they get enabled later it will be announced here first.

There is also a full command and permissions reference for GriefPrevention on the Bukkit project page — Command and Permissions Reference. Note that this is the reference for the original plugin; the 3D fork adds the commands listed above on top of it, so anything not in that list is the new stuff.